Trap for wild boars and deer, strong, tread only

*Not compatible with the Fare Asahi Shiki Trap that was previously sold at our store.

Among the popular tying trap strong type, this product is recommended for those who already have the pedestal and spring parts. * Only the tread part is sold separately, without the pedestal or spring part. Please select the size that fits your pedestal before purchasing.

Please check before ordering

The diameter of the tying trap that can be used varies depending on the area where the capture activity is carried out. Please check in advance which of the following 1 to 3 applies, and select the appropriate size.

1: In order to prevent erroneous capture of Asian black bears, etc., areas where the diameter of the ring of the leg tie wire (minor diameter in the case of an ellipse) exceeds 12 cm is prohibited.

2: Areas where the regulation of 1 above has been relaxed and traps with a ring diameter (minor diameter in the case of an ellipse) exceeding 15 cm are prohibited.

3: Areas where it is possible to use traps with a ring diameter exceeding 12 cm to capture the increasing number of wild boars and sika deer.

*Even within the same prefecture, regulations may differ depending on the area. For details, please contact the section in charge of the local government in the area where you conduct the capture activities.

Individual sales of footboard only

This page is a single sales page for the footboard only (no pedestal). Recommended for those who have a pedestal and want to make the spring part themselves, or for those who want to replace the broken treads. * When setting up, it is necessary to set the tread and spring. Click here for a product that includes a tread and pre-assembled springs. Also, click here for a product that includes a tread and base (without spring).

tread

Bury the attached PVC pipe pedestal in the ground, use a toothpick to adjust the load, and place the footboard on top of it. When the beast steps on the tread, the tread drops into the pedestal and the rail bounces upwards.

Kukuri Trap Operation Video

spring part

It is an essential part of a tying trap that consists of wires and springs. Attach the wire loop (snare) that wraps around the animal's legs to the rail of the footboard and use it by compressing the spring.

Kukuri trap capture video

Features of Trap Tread Strong

The board is resin instead of wood

The tread part has been improved from conventional wood to resin. It is more durable than the wooden board, and since the board does not absorb water, there is no need to worry about malfunctions due to swelling or peeling due to absorbing water. It has been improved to be able to handle rainy and snowy conditions.

Explosion prevention mechanism

Equipped with a safety device (holding metal fittings) that can hold down the rail (the part where the wire is attached to tie the legs) to prevent malfunction. You can carry it around with confidence even when the spring is under tension.

You can adjust the load that triggers the trap.

The tread set consists of a tread that the animal steps on and a PVC pipe that serves as a pedestal, but the pedestal has 6 holes that point to toothpicks, and the tread plate falls off according to the number of toothpicks that point to the PVC pipe. You can adjust the load.

We also sell replacement trap parts.

The treads can be used many times as long as they do not break, but the parts used for the springs are consumables. We also sell replacement parts starting from 1 piece.

Components of a tying trap

We also recommend a self- made kit that is a bargain with each component set.

01: Push spring 02: Wire rope 03: Aluminum sleeve 04: Sarkan

05: shackle 06: tie fitting 07: stopper (single) 08: stopper (double)

09: PVC pipe set 10: Footboard